Date:         Wed, 12 Jan 2005 01:27:43 -0500
Reply-To:     tolga <tolga@MAC.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         tolga <tolga@MAC.COM>
Subject:      Re: Exhaust fastener sizes needed
Comments: To: jim@KARMANNGHIA.COM
Content-Type: text/plain; charset="US-ASCII"

Jim, do you have a similar list of hardware for the 1.9 watercooleds?

>Date:    Tue, 11 Jan 2005 12:05:22 -0800
>From:    Jim Thompson <jim@KARMANNGHIA.COM>
>Subject: Re: Exhaust fastener sizes needed
>
>I use to make up and sell hardware kits for this purpose with the following
>components:
>
>Cylinder Head Kit (Both Heads):
>4 ea  Bolt Din 933 8x30
>4 ea  Hex Nut 8mm x 1.25mm pitch
>8 ea  Flat Washer Din 125, 8mm ID
>
>Header Pipes to Collector Pipe Kit
>4 ea  Bolt Din 933 8x30
>4 ea  Hex Nut 8mm x 1.25 pitch
>
>Collector Pipe to Cat Converter Kit
>3 ea Bolt Din 933 8x45
>3 ea  Hex Nut 8mm x1.25 pitch
>
>Hope this helps
>
>Jim Thompson
>84 Westfalia 2.1 "Ole Putt"
>oldvolkshome@earthlink.net
>jim@karmannghia.com
>http://www.oldvolkshome.com
>***********************
>----- Original Message -----
>From: "Jim Felder" <felder@KNOLOGY.NET>
>To: <vanagon@GERRY.VANAGON.COM>
>Sent: Tuesday, January 11, 2005 9:11 AM
>Subject: Exhaust fastener sizes needed
>
>
>> When I reinstall my 2.1L exhaust system after the heads go back on, I
>> would like to replace all the fasteners in stainless steel. I can get
>> them all locally, but of course the supplier can't advise me as to what
>> to buy.
>>
>> To save a lot of ETKA time and multiple trips, does anyone already have
>> a complete list from the cat to the heads, including the (6mm?)
>> allen-head bolts that fasten the small nipple on the rear right head
>> under the alternator mount.
>>
>> Thanks,
>>
>> Jim
>
>------------------------------