Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 12 Jan 2005 13:45:15 EST
Reply-To:     JordanVw@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         JordanVw@AOL.COM
Subject:      Re: FS: '86  Syncro with '91 Subaru 2.2L. $1800   Tacoma/Seattle,
              WA
Comments: To: gholt@U.WASHINGTON.EDU
Content-Type: text/plain; charset="US-ASCII"

In a message dated 1/12/05 1:41:13 PM Eastern Standard Time, gholt@U.WASHINGTON.EDU writes:

> > Sorry for any cross-postings... > > For sale: 1986 VW Vanagon Syncro with 1991 Subaru 2.2L > motor. Tacoma/Seattle, WA > > $1800 > > Van runs with engine conversion but needs some finishing touches. Also > would be a good parts car to go from that tried VW motor to an AWD > powerhouse. Details are below. See www.kennedyeng.com or > www.smallcar.com/convert.htm for more information on the conversion. > > Body: gray with some small dents/scratches on the both sides. Minor rust > at bumpers and seam behind forward doors (Mass. car originally). > > Interior: Black and gray. Front part (driver and passenger area) in > decent shape. Back half is stripped for built in bed (not installed). I > have a separate rear seat half installed. Headliner good, interior panels > alright except sliding door, which is missing. > > Drivetrain: 1991 2.2L subie converted using Kennedy Eng. kit. New water > pump, timing belt, clutch, etc. Custom skidplate for oil pan and custom > exhaust. 5 speed transmission (VW) with granny-gear. No differential > locks. > > What it needs: Currently the motor runs, but the mixture is significantly > off and therefore probably not drivable. My guess is the harness needs to > be redone although it could be one of the sensors (multiple codes from > ECU). The cooling system is also a temporary setup and would need to be > finished properly. Transmission is noisy, likely the main shaft > bearing. Because of limited time and my new graduate student salary have > chosen not to put any more effort ($$) into the vehicle. It would be the > new owner's responsibility to move it from Tacoma, WA. > > Email gholt@u.washington.edu for more details and pictures or call > 206-227-9930 (serious inquires only please). >

sounds like an awesome deal for the price.. someone should snap this up..

chris


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.