Date:         Fri, 14 Jan 2005 17:50:26 -0700
Reply-To:     Gerald Masar <azsun99@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Gerald Masar <azsun99@EARTHLINK.NET>
Subject:      spring type tube benders
Content-Type: text/plain; charset="iso-8859-1"

I will be transferring a second propane tank from my '88 Westy to my '90 Westy, to the
same location right side below the sliding door, and probably have to bend some new
tubing
to correct PO mistakes (no regulator on #2 tank; just feeds into #1 tank upstream of
the reg.)
Do the spring-type tube benders work adequately?

Thanks,
Jerry

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.