Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 23 Jan 2005 04:50:23 -0700
Reply-To:     jimt <camper@TACTICAL-BUS.INFO>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         jimt <camper@TACTICAL-BUS.INFO>
Subject:      Re: hole saws/floor cutting
In-Reply-To:  <15614-41F327F5-8040@storefull-3175.bay.webtv.net>
Content-type: text/plain; charset="ISO-8859-1"

Or in it as well. I have seen people ignite vehicles with the cutting torch. Strangest fire I saw caused was with a plasma torch. It was on one of those TV shows. They didnšt show the fire but showed what was left and why. They were cutting through the bottom of a pan from underneath and hit a fancy mag alloy piece up on the inside that they had forgotten to remove. Instead of small hole in pan to put in the new shifter mechanism they had a very strange shaped hole to rework. jimt

On 1/22/05 9:28 PM, "Robert Cardo" <rrecardo@WEBTV.NET> wrote:

> If you guy's are afraid of getting bit by a drill biting in with a hole > saw on the end of it, do the job the fast and easy way. > > Break out the cutting torch. > > Pop, > Ssssshhhhhhhhhh, > Done. > > Might be a good idea to take a look at what's under the Van prior to > lighting up. > > RC > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.