Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 22 Jan 2005 12:43:32 -0800
Reply-To:     Jim Arnott <jrasite@EONI.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Arnott <jrasite@EONI.COM>
Subject:      Re: cutting hole in van floor
Comments: cc: azsun99@EARTHLINK.NET
In-Reply-To:  <1e9.33f3b6c4.2f2407ee@aol.com>
Content-Type: text/plain; charset=US-ASCII; format=flowed

Contact your local electrical contractor. Might be able to use a 2" hole punch for a six-pack or two of decent beer.

Jim

> In a message dated 1/22/2005 10:10:40 AM Pacific Standard Time, > azsun99@EARTHLINK.NET writes: > > >> I need to cut a 50mm (slightly less than 2") hole in the floor of my >> '90 >> Westy to >> install a gas furnace. It will be in the back corner of the small > > The first lemming to lead his peers off the cliff is a bold and decisive leader.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.