Date: Sun, 23 Jan 2005 01:31:55 -0500
Reply-To: David Beierl <dbeierl@ATTGLOBAL.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: David Beierl <dbeierl@ATTGLOBAL.NET>
Subject: Re: front blower
In-Reply-To: <000001c500af$07af8f70$6601a8c0@cbetest12>
Content-Type: text/plain; charset=us-ascii; format=flowed;
x-avg-checked=avg-ok-198F2CFB
At 13:20 1/22/2005, Jere Hawn wrote:
>Has anyone had this problem? I recently replace the front blower assembly
>in my 88 GL with a blower assy from an 87 Wolfy. I hooked everything back
>up and I get minimal heat blowing but I can hear the blower working at all
>three settings. I get no air out of the side vents and minimal out of the
>floor and on top of that I have a substantial draft coming in from the area
>of the hoses.
One or both of the two bypass flaps that let ram air pass around the blower
is stuck open or quite likely lying in the bottom of the heater box. Ram
air works just fine, correct?
They are quite light, postcard-size roughly, and have molded pins extending
from the upper corners to form a hinge along upper edge. These pins snap
into little clips molded into the box proper, and they hang suspended from
the clips and close off two big holes that short-circuit the blower output
right back to the input. Blower pressure keeps them closed; when ram air
pressure exceeds blower output pressure it drives them open and the ram air
comes straight in. To hear them working, drive along at 25 or so with no
blower and suddenly turn the blower to full speed. If they're working
you'll hear them snap shut quite emphatically.
They are right bastards to work on because a) the hinges are up in a nasty
little triangular corner and b) they hang from the *open* end of the little
clips, so the pins wear triangular and so to the clips; then they jam or
fall out. You have to rebuild the pins with epoxy or summat and *also*
provide something for them to pivot on. I've had success with sinking
heated brads through the case from some appropriate direction to give a
bearing surface. Not elegant by any means but it's worked for a number of
years on...three? four? different beasts. Someone who didn't get ambushed
and set out to solve it deliberately could do enormously better I'm
sure. Brass would prolly be a good idea so they don't turn into little
files with rust.
good luck, mate.
david
The sealing foam will have disintegrated but I don't view it as important,
just rub off the dead bits with your thumb and the fuzz that's left will be
plenty good enough.
--
David Beierl - Providence RI USA -- http://pws.prserv.net/synergy/Vanagon/
'84 Westy "Dutiful Passage," '85 GL "Poor Relation"
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.7.1 - Release Date: 1/19/2005