Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 22 Jan 2005 11:19:13 -0700
Reply-To:     jimt <camper@TACTICAL-BUS.INFO>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         jimt <camper@TACTICAL-BUS.INFO>
Subject:      Re: cutting hole in van floor
Comments: To: Gerald Masar <azsun99@EARTHLINK.NET>
In-Reply-To:  <006701c500ac$70fe0e00$b809b83f@computer>
Content-type: text/plain; charset="ISO-8859-1"

On 1/22/05 11:01 AM, "Gerald Masar" <azsun99@EARTHLINK.NET> wrote:

> I need to cut a 50mm (slightly less than 2") hole in the floor of my '90 Westy > to > install a gas furnace. It will be in the back corner of the small compartment > to the > left of the fridge. I looked at holesaws yesterday, and besides being > expensive to buy > one for just this job, I am wondering how well they would work on the uneven, > ribbed > surface of the van floor. And the hole will come out 1/8" away from the main > side > beam. > Any hints, tips, suggestions on how to do this? > Thanks > Jerry > >

A hole saw will work but is tricky to control in that space. Done it. Extra damaged knuckles job. Coming out the bottom I suspect a propex furnace. Use a cheapie hole saw set from harbor freight or similar. A couple buck throw away.

•••••••••••••••••••••••••••••••••••••••• jimt Planned insanity is best. Remember that sanity is optional. http://www.tactical-bus.info (tech info) http://www.westydriver.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.