Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 26 Jan 2005 11:28:28 -0500
Reply-To:     tabe johnson <xtabe@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         tabe johnson <xtabe@YAHOO.COM>
Subject:      Re: How does a leak down tester work???
Comments: To: Stan Wilder <wilden1-1@sbcglobal.net>
In-Reply-To:  <000701c50370$054dc350$2bdf5e44@noner4688xfd1h>
Content-Type: text/plain; charset=us-ascii

Hi Stan,

Not sure what you mean by this... Can you break it down for me? (heh heh.. get it? Break down? I kill myself)

Thanks!

--tabe

--- Stan Wilder <wilden1-1@sbcglobal.net> wrote: > Actually what you're missing here is that you're running an 8.1 to 8.5 > compression engine and the good numbers are not significantly differently > than the bad numbers. > Its called PARANOID MAINTENANCE. > In my ten years of running 83 Westphalia an 76 Porsche 912e I'm confirmed > that my engines never failed but I could have made the same miles with just > regular manual maintenance. > 20/50 Wt isn't a fix. oil coolers aren't a fix................. it Sorta > breaks down to Desert Racer or East coats commuter. > > Stan Wilder > Engine Ceramics > 214-352-4931 > www.engineceramics.com > ----- Original Message ----- > From: "tabe johnson" <xtabe@YAHOO.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Tuesday, January 25, 2005 11:40 PM > Subject: How does a leak down tester work??? > > > > I understand the idea behind leak down testing but > > have questions for someone who's actually used a > > leak down tester before. I haven't. > > > > To get your % leakage number, do you just pressurize > > the cylinder, cut off the airflow, and measure the > > pressure after, say, one minute of the air slowly > > leaking out of the cylinder? > > > > Or - Do you apply a constant pressure through a flow > > restrictor to the cylinder and measure the pressure > > on the cylinder side of the flow restrictor? If so, how > > do you decide how large a restriction to use? > > > > What am I missing here? > > > > Thanks! > > > > --tabe johnson > > xtabe@yahoo.com > > Leaky Head Westy

______________________________________________________________________ Post your free ad now! http://personals.yahoo.ca


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.