Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Sat, 22 Jan 2005 22:02:10 -0700
Reply-To:   "Gary Lee, Vanagon Racks" <gary2a@TELUS.NET>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   "Gary Lee, Vanagon Racks" <gary2a@TELUS.NET>
Subject:   Re: hole saws/floor cutting
Content-Type:   text/plain; format=flowed; charset="iso-8859-1"; reply-type=original

>Plasma torch also would work very excellently if you have the grand to buy >one.

I wish they were that cheap :) I have one that cuts up to 1" thick. It makes heat and smoke and the plasma stream is torch-flame like. I have a choice, and I choose to use a holesaw for making that particular hole in the van floor.

I notch hundreds of pieces of metal tubing with holesaws. In my experience, bi-metal hole saws are all pretty much equivalent in quality and ease of cutting. Even if you wanted to buy a really good one for lots of money, it wouldn't work much better than a cheaper one. I used to buy lenox holesaws at about $10 each. They don't last any longer than the $6 no-name bimetal saw. The lenox are ground and are a little more accurate and are centered a bit better however. Like I said before, the teeth tear off before they get dull. And when it is that the teeth accidentally tear off, you can never know.

Gary Lee http://www.telusplanet.net/public/gary2a/vw.htm


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.