Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 23 Jan 2005 18:08:42 +0000
Reply-To:     mtbiker62@COMCAST.NET
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Bob Stevens <mtbiker62@COMCAST.NET>
Subject:      Re: extra gauge install options
Comments: To: Edward Maglott <emaglott@BUNCOMBE.MAIN.NC.US>

Ed, I have that pod if you want it. I put oil p/t gauges in it and mounted it in the ash tray hole prior to me current set up. (WRX 3-gauge pod) I ground off the rear-bottom edge so it would tip up slightly so I could see it on the down-sloping dash area where the ash tray was. The left gauge hole is slightly back-set compared to the right, made for mounting right of the driver, slightly facing that way. In other words, both gauges are not flush and facing straight ahead. Photo of my current set up: http://tinyurl.com/4mqfm

Bob Stevens http://groups.msn.com/BobsPhotoShare/87westysyncro.msnw

-------------- Original message --------------

> Well, I'm still hemming and hawing about adding gauges to my '86. It is > AT, with the big analog clock. I want to keep that gauge cluster. I would > like to add a small tach, and I also have a 2" oil pressure gauge I'd like > to add. So I was looking for a small aftermarket tach to add like Paul did: > > http://www.pauldottrip.com/84vanagon/tach/tach.html > > Then I started to think that I should get a 2" in-dash tach and mount it in > a 2 gauge cluster with the OP gauge. (Like this: http://snipurl.com/c88w > ) So I've been Looking around for such a cluster and where to put it if I > did get one. Looks like the center of the top of the instrument panel > cover will have the gauges slightly obscured by the top of the steering > wheel. Thought about a single gauge pod on either side of the cover, like > Paul's tach. But I would rather be able to glance and see at least both > tach, and OP at one place. Preferably close to the water temp gauge > too. I see a lot of A pillar clusters advertised, none specifically for > vanagon of course. That seems like it might be a good use of > space. Anybody done this? What popular vehicle has an A pillar similar to > a vanagon? > > Anyway, I'll quit rambling and ask for examples of what people have done! > > Edward


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.