Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2005, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Sun, 30 Jan 2005 17:20:14 -0500
Reply-To:   Ken Lewis <kdlewis_wasting_time@ACCESS4LESS.NET>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Ken Lewis <kdlewis_wasting_time@ACCESS4LESS.NET>
Subject:   Re: Setting Timing Gear
Comments:   To: Ken Winsor <kwinsor@STNY.RR.COM>
Content-Type:   text/plain; charset="iso-8859-1"

Ken, Is the cam gear the proper size for your case? As I under stand it there exsists a plus and minus size. With the case still split and cam installed; turn the crank. If the cam lifts out the gear is too big. Ken Lewis http://neksiwel.20m.com/ ----- Original Message ----- From: "Ken Winsor" <kwinsor@STNY.RR.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Sunday, January 30, 2005 4:12 PM Subject: [VANAGON] Setting Timing Gear

I'm methodically getting ready to reassemble my 2.1 ('88 Westy). Thanks to those that have given me advice and support already. Here's my latest issue.

I want to install the timing gear, along with the crank, and cam before I assemble the case halves. I'm trying to minimize future problems, like loosing those two washer / bushings down in the case while installing the gear when the case is back together.

So I have the left side case secured, and I installed the crank, cam (yep .. aligned the "dots") and slipped the pulley on. Lined up the pulley mark with the case split to get #1 at TDC, and then used the distributor to install the gear to get the rotor pointing right at the #1 notch, and I think I'm all set. But is this the compression or exhaust cycle?

So I'm staring at the cam lobes to try and figure out if they can tell me which cycle I'm on, but I thought I would ask if anyone has advice?

Also, I ordered the case sealant from VW ($47 .. wow!) but didn't know if that yellow nut sealant that comes with my gasket kit can be used on the case bolts? Does it stand up to oil?

Thanks,

Ken


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.