On 2/8/05 11:11 AM, "Jack" <john.cook58@VERIZON.NET> wrote: > I've stayed out of this but a couple of comments need some response. > > 1. Star washers. Do NOT use between terminal and ground surface > unless absolutely necessary to cut through paint or something. If > they heat up it's because a higher resistance has been introduced > into the electrical contact system via the washer. Bad! > > 2. Threads. Grease, anti-seize, peanut butter ... doesn't matter! > Any good contact system relies on the flat surfaces, NOT on the > threads. If using some substance on the threads creates a higher > resistance then something is wrong. > > 3. A typical stackup. Per "best practices" in industry. > Body metal. Bright & clean bare metal. > Ideally, surface is plated or tinned. > Terminal (ring or spade). Bright & clean. Proper connection > to wire assumed (different set of problems). > Flat metal washer. Sometimes omitted. > Lock washer. > Purpose is to maintain high contact pressure. > Nut or bolt/screw head. > > 4. If in bad environment, cover stack with grease or suitable > compound - I prefer silicon (e.g., DC4). Helps prevent corrosion and > eventual corruption of the gas tight metal/metal contact. > > There are, of course, variations on the above. Key point. Well > designed ground systems do NOT normally rely on threads for > electrical contact unless there's no choice. > > //Jack > '85 GL > > When assigned in tactical outfits with a lot of exposed to the environment grounding the same rules applied Grounding surfaces polished clean and depending on metal tinned. Only a flat washer between contact and ground surface permitted and it had to be larger diameter than the contact being used, and be of the correct metal type. Lock washer on top of contact with preferably another smaller flat washer first (metal type again if used). Then an antisieze compound or grease lightly applied to top area threads and nut applied. Then depending on type of exterior connection sometimes grease over everything afterwards. There were also rules on what the ground was made of (braid, solid, multiconductor, etc) Interior grounding was not much different except no grease allowed. Grounds inspected on every scheduled inspection for corrosion. •••••••••••••••••••••••••••••••••••••••• jimt Planned insanity is best. Remember that sanity is optional. http://www.tactical-bus.info (tech info) http://www.westydriver.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.