Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2005, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 9 Feb 2005 21:04:11 +0100
Reply-To:     Jaap Nauta <bus.mail@IAE.NL>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jaap Nauta <bus.mail@IAE.NL>
Subject:      Re: Vanagon shocks and coils spring
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

I'm a bit confused now: in some other article I read that the most probable cause for "sweaky" suspension is worn upper ball joint. With a description how to remove them similar to the one Shawn wrote. So what should you replace, the bushing or the ball joint? When changing the bushings, after install you have to secure the bushings with spot welds to prevent them from turning (according to the Bentley). I don't have welding equipment, so how bad is it when you don't do this?

Jaap '87 diesel

Shawn Wright wrote:

> On 9 Feb 2005 at 9:42, The Bus Depot <vanagon@BUSDEPOT.COM> wrote: > > > >>> But...my front and rear coil springs are sweaky. >>> -What causes this? >>> >> >> Most commonly a front suspension squeak is caused by worn upper >> control arm >> bushings: >> >> http://busdepot.com/details.jsp?partnumber=251407077 >> > > > Yup. Can be confirmed by spraying WD-40 or similar into the bushings > and driving. > Don't expect it to last very long, but it can confirm the source of > the noise. I sprayed a > liquid moly grease in mine for about a year every month of so before I > finally replaced > them. This was 5-6 years ago, and I only did one side. The other side > is still fine. the > job can be done without press, but it requires a vise and lots of > banging with a > hammer. You will deform the old one getting it out, but this can then > be used to install > the new ones without damaging them. > > While you're in there - did you install the front upper shock rubber > bushings that > came with the KYBs? If so, and you have knocking in the front end, > this is the cause. > I did this, and was told about the problem. I had kept the old > bushings (rubber > donuts), so I reinstalled them, and knocking is gone. > > -- > Shawn Wright > I.T. Manager > Shawnigan Lake School > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.