Date:         Tue, 8 Feb 2005 13:39:49 -0800
Reply-To:     Jim Thompson <jim@KARMANNGHIA.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Thompson <jim@KARMANNGHIA.COM>
Subject:      Re: Oil Drain Plug Gasket
Comments: To: Peter <peter.linsley@GMAIL.COM>
Content-Type: text/plain; charset="iso-8859-1"

The original is a copper flat washer, part number is the same as you noted
below and is the same as N0138492, which is an acceptable alternative (itsa
teensy bit thicker).  I have on occasion used the air cooled variety copper
"crush" washer without leakage problems - Part # N0138152, never re-use them
of course.  These are more readily available from your local VW shops (Size
is 14idx20od for the flat or crush size).

Hope this helps

Jim Thompson
84 Westfalia 2.1 "Ole Putt"
oldvolkshome@earthlink.net
jim@karmannghia.com
http://www.oldvolkshome.com
***********************
----- Original Message -----
From: "Peter" <peter.linsley@GMAIL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Tuesday, February 08, 2005 11:07 AM
Subject: Oil Drain Plug Gasket


> Hello again,
>
> So all I need now for my first oil change is a drain plug gasket. My
> overpriced overfriendly local VW dealership does not have them on
> stock, in fact, they couldn't locate a dealership in the bay area that
> had one. How strictly should I keep to the specs on this part? Anyone
> know any suitable substitutes or a good FLAPS in the bay area that's
> likely to have one? The part number I have is N 013 8293 and I need it
> by tonight so internet isn't going to cut it. It's for a '89 Westy.
>
> Cheers.