Hi Marc, An excellant fuel pressure guage can be made by looking in the yellow pages for companies that make up hydraulic hose or welding supplies. Our town's hose shop has guages for less than $10. Get a foot or so of high pressure hose while your there, 5/16 or 7mm I think, double check, This hose slides over the bleeder screw/ hose barb tee fitting in the fuel line. It's located near the distributor base, Anyway, also get a brass tee female thread. The three ports are: one for the guage, one for the hose barb, and one for a schraeder valve, its to bleed air out of theline, and is the same thing as a air valve in a tire. NOTE to ensure safe practices when you are burping the guage, and are disconnecting after testing. Mark Keller 91 Carat |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.