Date: Wed, 23 Feb 2005 14:17:40 -0500 From: tabe johnson <xtabe@YAHOO.COM> Subject: Re: Timing 1.9,2.1 engines Timing these engines is straightforward, though reading Bentley doesn't make it sound simple! Here's a paraphrased posting of Dennis Haynes' which explains it most clearly:
Ignition Timing Procedure 1986+ Vanagon 2.1L Digifant 1. Warm engine to normal operating temp. 2. Shut off engine. 3. Connect timing light. 4. Connect tachometer. (optional) 5. Restart engine and run up to more than 2000 RPM. (~2500 works well) 6. Disconnect BLUE CONNECTOR from Temp sensor II. (Don't catch your tie in the belts!) 7. Maintain engine RPMs ~2500 and point timing light at timing mark. (5 BTDC) 8. If timing mark aligns with split line between crankcase halves timing is correct. 9. If not loosen distributor and make adjustment. Don't forget to retighten the distributor if you had to loosen it. Tabe, I don't agee with this timing of total 5 degrees before Top Dead Center at 2500 Rpm. Total advance should be all in by 2500 RPM, and that is 35 degrees plus idle for a total advance of 40 degrees. Perhaps your reading Dennis's instructions incorrectly. Mark Keller 91 Carat |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.