Date:         Sat, 26 Feb 2005 15:52:53 -0800
Reply-To:     Philip Chidlaw <pchidlaw@MCN.ORG>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Philip Chidlaw <pchidlaw@MCN.ORG>
Subject:      Re: Intermittent starting problem and temp II
Comments: To: THX0001@AOL.COM
In-Reply-To:  <6b.3fc1f90f.2f515ed0@aol.com>
Content-Type: text/plain; charset="us-ascii"

Thanks George. I had occasion today to make the 2-hour drive to town (Santa
Rosa) for domestic provisions, and stopped in at just such a parts place -
Smothers Parts - where I found just what I needed. Actually they found it
after 5 minutes of searching through a catalog.

This one came pre-wired with 2 leads. In the van, it looks like 3 wires
attach to the 2 contacts in the connector, with the 2 white wires on 1 side
and the brown on the other. At least 1 must go to the ecu. Can anyone direct
me to the Bentley wiring diagram covering this? -Phil



-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
George Goff
Sent: Friday, February 25, 2005 9:11 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Intermittent starting problem and temp II

In a message dated 2/25/05 10:20:55 PM, pchidlaw@MCN.ORG writes:

<< Does anyone know of a source for a new temp II connector? >>

With all that Bosch stuff out there a good auto parts house might have what
you need.  In the more populated areas there are fuel injection specialty
shops
who might be able to help.  If nothing else, perhaps the connector shown in
the following link might work.

http://store.summitracing.com/partdetail.asp?part=MSD%2D2400

Or, go to a junkyard and kife a connector from a European car harness.

George