I re-used mine about 2 years ago... hasn't leaked yet... Of course, YMMV. Good luck! The 6-mm socket head bolts sound familiar too... I ended up shortening an allen wrench by about a quarter-inch to be able to get it into one of these right below the pump. I don't remember if I *had to* pull my distributor, or if I just pulled it to replace the o-ring on that (a little bit of oil was leaking in the the area... still is, must be the fuel-pump block-off)
At 02:50 PM 3/4/2005 -0800, roger sisler wrote: >Can any one tell me if I can reuse that plastic o-ring on the upper water >crossover pipe?Cant find a new one anywhere , or any vendor who knows what |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.