<< I don't know what Rust Mort is, but it and naval jelly are similar. >> The problem with either of these products is that, as stated in bold type, they are supposed to be rinsed with H2O prior to priming. Now, that can be a problem on a seam which wicks in water like a sponge. Once the moisture is in the seam how do you dry it out completely? A shot from the good old blow gun? That may produce the opposite effect than what is desired and drive the water farther into the seam. An old timer machinist once told me that he could tell how good a hand was by just watching him clean a machine after a job. If the guy used a blow gun to clear away the swarf, he was a hack because he was not blowing the stuff off, he was blowing it in. Plug in the heat gun, Homer. George |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.