About to put a set of alloys on my 83 and want to make sure it's done right. Am I reading the Bently right when it says to remove the rear drum and hub, then press them out / back in? Is there a better or easier way to do it? I'm assuming the studs from the donor could be used, but it would be simpler and easier to just replace them. What length of stud should I be getting? john |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.