Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2005, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 9 Mar 2005 20:57:32 -0800
Reply-To:     Leo Lee <leo0365@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Leo Lee <leo0365@SBCGLOBAL.NET>
Subject:      Re: Help! Cylinder head stud broken
In-Reply-To:  6667
Content-Type: text/plain; charset=us-ascii

Thanks Paul for replying my post, do you remember which stud was it that was broken. Without the one in the lower middle might be able to hold better. I have searched that achieve, it appears that it is possible to replace the broken stud, but a very tough job. Not sure I can handle it. It would be nice if someone have can share their experience in replacing broken stud.

Paul Guzyk <paullist@GUZYK.COM> wrote: I have seen a head held on with 7 studs, but who knows how long it ran before it broke again. (It was broken again when I got the van).

The guy had tapped the stud hole in the head and filled it with a bolt (and sealant) to keep fluids from coming though.

You could try this, but I doubt it's a good solution.

You may in in a pickle my friend. :(

-Paul

>The first question is, can I block the stud tunnel with some sort of >liquid steel and run the engine with 7 nuts to secure the head? >The second question is how do I fix the broken stud? Do I have to >take to whole engine off? >Any suggestion will be greatly appreciated. Thanks


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.