Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2005, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 9 Mar 2005 21:39:13 -0800
Reply-To:     Leo Lee <leo0365@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Leo Lee <leo0365@SBCGLOBAL.NET>
Subject:      Re: Help! Cylinder head stud broken
In-Reply-To:  6667
Content-Type: text/plain; charset=us-ascii

Thanks Dennis for the very useful information. Do you have a good procedure to remove the broken stud and how do I screw the new one into the cylinder block? I think I have two of those soft studs, one broken, the other one should be replaced too. Thanks again

Leo

Dennis Haynes <dhaynes@optonline.net> wrote: The nut going soft while tightening is actually a sign the stud was stretching. If the engine was once overheated, all the studs are suspect. If there is any corrosion on them, they must be replaced. You will need to remove the head, and at least lift the cylinder out slight to replace the stud. They are fairly tight in the case so some imagination will be needed to remove it. Any others that tightened weirdly should also be replaced. It is also a good idea to replace the nuts or at least chase the threads with a quality tap. Never fill the nuts with oil or sealer. Only apply to the stud threads. Good Luck.

Dennis


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.