Greetings all
The heads are done and all is well. I started this project before Christmas and have had many delays. One of the biggest was that I find it difficult to work during the week, so this was a perpetual weekend job (I have no life)
What did I learn:
1. it is not that difficult 2. I bought tools that really helped a. A package of small awls (various shaped ends) b. Disc grinder (very helpful on the exhaust) c. a 30mm socket to turn the engine d. tap and die for the head bolts 3. I seem to be constantly running out of nuts and bolts until it just bought a bag (I replaced as many as I could) 4. having the cylinders come off is not a problem (I borrowed a ring compressor, I'll buy one next time) and in fact next time I'll just take them out to replace that lower o-ring. And to lap in the tops of the cylinders 5. buying a whole engine gasket set was a good choice 6. I ran out of exhaust gaskets twice 7. I replaced the tail pipe since I had the exhaust out any ways 8. I used two drop lights in a well lit garage (good idea) 9. I have a set of those ratchet combination wrench sets (very useful) 10. I changed all the exhaust nuts and bolts to metric 13 mm 11. I should have bought a tap and die for the standard 13mm bolts that I was using 12. have plenty of ratchet extensions and at least one universal joint 13. I used rope and a bungee cord to tie up the manifold and A/C unit (hung it from the top hatch door lip) 14. rear tires are best off 15. having a foxtail to keep the are clean (creeper kept skidding on the little rocks that fell off) 16. have plenty of coolant catchers I used the old turkey roster pan and two small plastic trash cans 17. smacking your forehead on the trailer hitch causes potty mouth no matter how many time you do it 18. having a bench grinder with a wire wheel allowed me to clean most parts and exhaust flanges 19. I didn't separate the cat converter from the muffler 20. I used compressed air to clean parts (used my scuba tanks) 21. minimize the number of tools that you have out
If had to do it again (or when) if you are not close to a parts store get all you parts, think ahead, VW parts dept isn't open on the weekend, washers and sockets always roll way beyond your reach; if you don't have them you will dream of air tools.
For those think of doing it, jump in, you can do it, when in doubt label and clean.
Jere 90 GL/Carat-a-version |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.