Date:         Mon, 4 Apr 2005 00:19:19 EDT
Reply-To:     Oxroad@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeff Oxroad <Oxroad@AOL.COM>
Subject:      Re: jb welding speedometer mounts
Comments: To: icecoldvw@HOTMAIL.COM
Content-Type: text/plain; charset="US-ASCII"

The corners of my speedo were pretty thrashed. I found a metal--looks like
galvinized metal--back for the speedo in a junk bus. I think it was a real early
Vanagon, maybe a 1980. That's the only one I ever saw, so I guess they're
hard to find. And I guess that makes this lousy advice. And since today is over
it also untimely.

BUT, for those looking for a fix in the future, locating one of these metal
speedo backing plates could make your life easier--in some small way. Just be
careful nt to overtorque sonce all that plastic is pretty brittle including the
screw receiving hole in the main part of the insturment cluster.

And, by the way, There's no question the metal piece is a genuine Vw part--it
had all the appropriate holes and so on, Maybe even had sticker(?) I haven't
been in there for some time. Wonder if VWOA still has any (LOL).

Anyway, maybe someone wiser knows when they stopped using the metal backing
plate for the speedo. That was a sad day.

Best,
Jeff
83.5 Westy
LA,CA


In a message dated 4/3/2005 10:43:48 AM Pacific Daylight Time,
icecoldvw@HOTMAIL.COM writes:


> Today's the big day, I'm JB Welding new mounts for my speedo.  From reading
> through the archives it sounds like my best bet it to make little 'forms' at
> each corner to hold the JB Weld.