Date:         Wed, 6 Apr 2005 19:04:12 -0700
Reply-To:     Daryl Christensen <aatransaxle@DIRECWAY.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Daryl Christensen <aatransaxle@DIRECWAY.COM>
Subject:      Re: First try at a trannie only pull - questions
Comments: To: jimt <camper@TACTICAL-BUS.INFO>
Content-type: text/plain; format=flowed; charset=iso-8859-1; reply-type=original

Jim
 I always support the engine so it won't drop more than 2 or 3 inches and
break-tweak-stretch the hoses and fuel lines while the tranny is out.
 If the input shaft is at all buggered at the end...the pilot bearing is
toast...replace it...
 A cheap harbor freight type tranny jack would make a huge difference over a
std type floor jack as far as stability.
 If you can get the clutch arm off (they rust on) you can pull the slave
bracket off and not have to bleed or take the stupid hard to get off slave
bolts off. Have fun..Daryl of AA Trans
----- Original Message -----
From: "jimt" <camper@TACTICAL-BUS.INFO>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Wednesday, April 06, 2005 4:21 PM
Subject: First try at a trannie only pull - questions


All the years I have pulled VW apart this will be the first time I am going
to try a transmission only pull.  Any tricks or warnings?

Thanks



........................................
jimt
Planned insanity is best.
Remember that sanity is optional.
http://www.tactical-bus.info (tech info)
http://www.westydriver.com