Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2005, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 2 Apr 2005 02:17:24 -0600
Reply-To:     Al and Sue Brase <albeeee@MCHSI.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Al and Sue Brase <albeeee@MCHSI.COM>
Subject:      Re: is my tranny near death?
Comments: To: Shawn Wright <swright@ZUIKO.SLS.BC.CA>
In-Reply-To:  <424DC45F.10802.14EA23D9@swright.zuiko.sls.bc.ca>
Content-Type: text/plain; charset=us-ascii; format=flowed

I do not agree about your r&p failure. I'd say the cause of your r&p failure was incorrect pinion depth or (More likely) backlash after replacing the bearings. Did you re- set the depth with a pinion depth setter? The book says you need to I never have, but do set the backlash and check for contact pattern. I would concurr about the syncro scratching that Greg is experiencing.. Synthetic oil and careful speed matching whil shifting will make the grinding much less. It will last that way for a VERY long time if you are gentle with shifting.

Al Brase

Shawn Wright wrote:

>On 1 Apr 2005 at 21:20, greg crone <l_levi1@YAHOO.COM> wrote: > > > >>I've got an 85 westy that has a slight grind when >>going from first to second. If I wait 2 or 3 seconds >>it doesn't happen...only if I try to shift right away. >>Is this the onset of the fabled vanagon syndrome? >> >> > >No, just standard 2nd gear syncros wearing out, very common on any manual trans. >Drain the oil, and get 3-4 qts of Redline MT90. It will make a difference, possibly >enough that you can go for years more before needing to rebuild. However, if you >find large chunks of metal on the magnet, as opposed to fine metal powder, then you >may want to consider a rebuild sooner. My ring & pinion failed soon after I replaced >all the bearings in the transmission. I suspect all the metal from failed bearings (slow >failure over several years) accelerated wear on the highly stressed ring and pinion. > >My '85 Jetta trans ground 2nd gear at 200k. I switched to Redline, and it still shifted >great at 480k! I have tried many other gear lubes, and Redline is by far the best. >Shawn Wright >http://zuiko.sls.bc.ca/~swright >'85 Jetta D >'88 Westy 2.1L, soon to be 1.6TD 5 speed >'82 Diesel Westy > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.