I don't have a picture of my install but here are two sites with photos that I found helpful when I did my install. I did an installation most similar to the second site. http://home.earthlink.net/~johndolsen/id13.html http://www.geocities.com/harald_nancy/plat_cat_heater.htm I ran my copper lines by creating a "T" under the sink, then ran the new tubing below the shelving, then to the floor and out of the cabinet. I then ran the tubing directly along the floor at the base of the step between the back and front compartments--and to the furnace. Obviously, that meant that I had to drill a small hole for the copper tubing to exit the cabinet wall. Note that it's helpful, if not necessary, to use flarenuts designed for propane tubing. I placed the heater at an angle slightly toward the door. This angle allows me to turn the passenger seat around while still leaving room for someone to sit in that seat and have a reasonable amount of room for their feet. The heater rests on a modest wood cabinet which holds the heater about 3 or 4 inches above the floor. The cabinet is held to the floor with only a few screws into the floor. I am still experimenting with the positioning of this heater so I don't want to create a permanent installation.
I'd like to make a suggestion based on my experience with these heaters. I placed the thermostat behind and above the rear of the driver's seat, on the wall above the sink. Unfortunately, this position seems to be significantly colder than the rest of the van. Consequently, the thermostat is slow to respond to the heat from the Platcat, resulting in an overheated van, unless I set the thermostat at a deliberately too-low setting. Because of this problem, I am going to move the thermostat to the outside of the closet above the engine compartment. I believe that position will all the thermostat to more quickly and appropriately respond to the heat from the furnace. A second suggestion: If you have a thermostat like mine, it doesn't have an "off" position. I ensure the heater doesn't engage at a low temperature when I'm gone by placing an in-line valve under a shelf inside the cabinets. By turning this to the "off" position, I can be certain the furnace doesn't engage by denying it fuel. However, a better solution, as another List member mentioned, would be to place a switch on the hot line that services the furnace and simply turn the thing off! I will make that addition soon. If any of this isn't clear, please respond with any questions. Dan 89 Westy 4 speed camper |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.