If you put your finger over the spark plug hole as you turn the engine then you will feel the compression stroke as the engine makes its way to TDC for the number 1 cylinder Bob.Donalds Boston Engine
----- Original Message ----- From: "Stan Wilder" <wilden1-1@SBCGLOBAL.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Friday, April 15, 2005 6:00 PM Subject: Re: Valve clearance not at tdc?
> The way I find top dead center is to watch the rotor as I turn the engine. > With a std shift I put the transmission in 2nd gear and rock the car until > the rotor is pointing at the notch in the distributor rim. With an > automatic > you'll need a wrench on the rear bolt. > With #1 spark plug removed I insert a piece of stainless steel (the flat > part of a disposed wiper blade, or a .030 brass bar 1/4" x 12" an Ace > Hardware item). > I drop this between the cylinder head and the piston top and rock the > engine > until I get a squeeze on the flat stock. > You might need to rock the car backwards at this time to drop the Feeler > fully in. > In most cases you'll be able to complete the compression stroke if you > deck > height is set properly. But in general you'll feel the "Feeler" bind > between > the piston and cylinder head both before and after TDC position. > You can take note of your timing mark then and mark that as TDC with a > drop > of paint. (I use white out or liquid paper). > If you have help you can lay under the van and have them rock the van > while > you're touching and evaluating exactly when the rockers develop free play > at > the stems. > If you do this right you only need remove the #1 spark plug. > > Stan Wilder > Engine Ceramics > 214-352-4931 > www.engineceramics.com > > > ----- Original Message ----- > From: "Nate Saylor" <nates@IMPULSE.NET> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Friday, April 15, 2005 4:01 PM > Subject: Valve clearance not at tdc? > > >> Bob's method. Once the lifters were pumped up I zerod them. but the >> odd thing is that when I zero passenger rear (I go by the rotor >> location, coupled with the marks on the pully) and move to the passenger >> front (next in line counter clockwise), I get clearance on one of the >> passenger rear valves. Why is this??? Am I going in the wrong order? >> I'm thinking this is why I have so much noise in my valve train. >> >> -Nate >> >> >> -- >> No virus found in this incoming message. >> Checked by AVG Anti-Virus. >> Version: 7.0.308 / Virus Database: 266.9.10 - Release Date: 4/14/2005 >> >> > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.