On 4/25/05 19:35, "Cary Chiang" <ccc1@VOLNY.CZ> wrote: > Hello Listees: > For an early '80s AC vanagon, where on the engine would oil > pressure (mechanical type, not electric) and temperature senders be > installed? Looking at the Bentley, I see the low oil pressure > sender on top of the engine, but I assume there are other places to > access the oiling system, besides that and the drain plug. Thanks > in advance! > > Cary > There are other locations but not the best. One is the plate to the side of the oil drain area. There are sellers for modified ones ready to take a VDO sender for temp. for pressure the best location is that oil pressure sender port but you will need to make an extender for it. VDO used to sell one but discontinued it. I made one with fittings from a local performance shop and Earls lines. Was actually cheaper than what VDO had wanted for theirs when it was available. •••••••••••••••••••••••••••••••••••••••• jimt Planned insanity is best. Remember that sanity is optional. http://www.tactical-bus.info (tech info) http://www.westydriver.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.