Whatever method you use, think ahead ,and remember that you will need to accurately retorque da nut. File a small match mark on the nut and bering housing so you can tell when yu have retightened enough.Just one of several ways to do this.I once used a 10 foot long cheater pipe to remove the nut.A "nut whacker" can be had from many vendors for about $5.This is a piece of cast iorn that fits over the nut. A breaker bar is attached and a hammer"whacks" the cast iorn. This is done while while downward pressure is placed on the breaker bar. Works good. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.