Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2005, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 4 May 2005 07:44:25 -0700
Reply-To:     Paul Guzyk <paullist@GUZYK.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Paul Guzyk <paullist@GUZYK.COM>
Subject:      Re: I got my frig to light -- LED change procedure:
Content-Type: text/plain; charset="us-ascii" ; format="flowed"

>Never did see the #$%^&&** sight glass. The LED light will changed out >tonight, using the Blue LED 276-316 from Rip-Off shack >

Here's a few notes if you are new to changing LED's. You need a little experience with soldering but that's about it:

1) Remove the LED panel with the two small phillips screws. 2) Pull out the entire panel about 12" then disconnect the large white electrical connecter. Do the rest of the work on a comfortable table. 3) Carefully pull out the grommet that holds the wire bundle so you can pull the circuit board away from the enclosure. 4) Mark the Propane LED area of the circuit board (front and back) with a Sharpie. The propane LED is in the row of 4, farthest away from the toggle switch. By marking the circuit board, you won't make the mistake of changing out the water level LED. 5) Remove the old LED by heating both solder pads simultaneously and pulling it out with small pliers. Or use de-soldering braid (Radio Shack 64-2090) or other "solder sucker" to remove the solder first. 6) Keep the white spacer ring under the LED, you'll need it with the new one. 7) Make sure the holes are clear so you can insert the new LED. You can heat up both pads with the soldering iron and insert the new LED that way, but it's easier if the holes are already clear. 8) When inserting the new LED, don't forget the White spacer and don't forget to insert it with correct polarity. If you look carefully at the bottom of the LED, it looks like a "D", one part of the circle is flat. Just match that to the others when you insert it. You can also see the anode and cathode posts through the plastic. They will have similar orientation to the other LEDs in the board. Background of LEDs is here: http://www.merg.org.uk/led/ 9) Make sure the LED is centered compared to the others and close to the board with the spacer. Solder it in. 10) Cut the excess LED wires. 11) Hook up the panel to the electrical connector. Let it dangle for now. 12) Test the fridge LED. 13) Once you confirm it works, install the grommet and screw everything back into place.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.