Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2005, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 1 May 2005 21:34:36 -0700
Reply-To:     gary hradek <hradek@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
Comments:     DomainKeys? See http://antispam.yahoo.com/domainkeys
From:         gary hradek <hradek@YAHOO.COM>
Subject:      california smog issues and synthetic oil
Content-Type: text/plain; charset=us-ascii

I have a 98 passat1.8t and 87 westy waterleaker. Finest german engineering you can buy. So at 4 dollars a quart for synthetic I am sold on the synthetic for my hot running Passat. My wife claims I am cheap so It is hard to say I can spend 4 dollars for a quart of oil and say I am sold on it but I am. I am wondering if the next time I need to pass smog with my vanagon if I should spend the 15 dollars extra to put in synthetic in hopes that I might pass smog as the last time I passed by a cocks feather. It is clear to me that the synthetic has a much lower vapor pressure. Anyone out there using this in their vanagons? thanks gary --- Automatic digest processor <LISTSERV@GERRY.VANAGON.COM> wrote:

> There are 20 messages totalling 1118 lines in this > issue. > > Topics in this special issue: > > 1. Stalling and running rough > 2. help interpreting starter problem (4) > 3. [Fwd: Re: help interpreting starter problem] > 4. Van/camper rentals in Europe? (2) > 5. Vanagon (4) > 6. Wasserleaker -- we will soldier on, but how? > 7. Camping in the Poconos > 8. no power in the low end > 9. Fri. - working on gravel surface > 10. Diesel vs. Gas > 11. Need Automatic Transmission (2) > 12. westy cold = rich > > ---------------------------------------------------------------------- > > Date: Sun, 1 May 2005 21:06:52 +0100 > From: Stew <stew@SWITCH99.F2S.COM> > Subject: Re: Stalling and running rough > > Joel, > Thanks for that. > I will give it a go on Tuesday when I get a day off. > Thanks again, > Stew. > > ------------------------------ > > Date: Sun, 1 May 2005 16:13:29 -0400 > From: Mike Collum <collum@VERIZON.NET> > Subject: Re: help interpreting starter problem > > On my '85 I installed a remote starter switch in the > engine bay as I got > tired of walking back and forth to the front when I > wanted to just run > the starter. It's a Wal*mart switch that cost me > about $2.98. It's > mounted on the passenger side firewall and one wire > runs to the > starter's BIG terminal with the other going to the > small one (works the > same as jumping the terminals at the starter). > > Anyway ... one can "jump" the terminals with the > starter installed which > will eliminate the ignition switch and its wiring. > > Mike C. > > > > Doug Demarest wrote: > > Hello, > > > > so I got a bit flamed on friday for an apparently > > bone-headed method of checking my old starter in > my 86 > > Vanagon 2.1 ...anyway, here is what I have now > and, > > being a novice, I'm not sure how to interpret it: > > > > Testing my starter at the FLAPS gave intermittent > > results--it worked on the first try, but then he > > couldn't get it to fire again. It was pretty old > and I > > decided to get a new (rebuilt) bosch starter > rather > > than continue to mess around. Unfortunately, I am > > still messing around. > > > > I installed the new starter yesterday. Upon > turning > > the key and i can hear the fuel pump and a click > of > > the solenoid but no cranking at all. > > > > My battery shows 12.6 volts. Upon turning the key > I > > measure 12.6 volts at the small wire that connects > to > > the solenoid. Regardless of the positon of the > > ignition key, I get around 12.4 volts at the long > > terminal screw on the starter that is connected to > the > > battery (is this normal?). With the key turned in > the > > ignition, I get .7 volts at the shorter terminal > > screw. With out the key on, I get 0. > > > > Is the solenoid bad on my new starter? My > intuition > > says I should get 12 volts at the shorter terminal > > screw if the solenoid is sending power to the > starter > > motor. > > > > Any help interpreting this is appreciated, > > > > doug > > > > ------------------------------ > > Date: Sun, 1 May 2005 16:18:40 -0400 > From: Mike Collum <collum@VERIZON.NET> > Subject: [Fwd: Re: help interpreting starter > problem] > > I forgot the caution .... Make SURE the transmission > is in neutral > before operating the switch. > > Mike > > > > On my '85 I installed a remote starter switch in the > engine bay as I got > tired of walking back and forth to the front when I > wanted to just run > the starter. It's a Wal*mart switch that cost me > about $2.98. It's > mounted on the passenger side firewall and one wire > runs to the > starter's BIG terminal with the other going to the > small one (works the > same as jumping the terminals at the starter). > > Anyway ... one can "jump" the terminals with the > starter installed which > will eliminate the ignition switch and its wiring. > > Mike C. > > > > Doug Demarest wrote: > > Hello, > > > > so I got a bit flamed on friday for an apparently > > bone-headed method of checking my old starter in > my 86 > > Vanagon 2.1 ...anyway, here is what I have now > and, > > being a novice, I'm not sure how to interpret it: > > > > Testing my starter at the FLAPS gave intermittent > > results--it worked on the first try, but then he > > couldn't get it to fire again. It was pretty old > and I > > decided to get a new (rebuilt) bosch starter > rather > > than continue to mess around. Unfortunately, I am > > still messing around. > > > > I installed the new starter yesterday. Upon > turning > > the key and i can hear the fuel pump and a click > of > > the solenoid but no cranking at all. > > > > My battery shows 12.6 volts. Upon turning the key > I > > measure 12.6 volts at the small wire that connects > to > > the solenoid. Regardless of the positon of the > > ignition key, I get around 12.4 volts at the long > > terminal screw on the starter that is connected to > the > > battery (is this normal?). With the key turned in > the > > ignition, I get .7 volts at the shorter terminal > > screw. With out the key on, I get 0. > > > > Is the solenoid bad on my new starter? My > intuition > > says I should get 12 volts at the shorter terminal > > screw if the solenoid is sending power to the > starter > > motor. > > > > Any help interpreting this is appreciated, > > > > doug > > > > ------------------------------ > > Date: Sun, 1 May 2005 23:22:42 +0200 > From: Didier Don <didier.don@WANADOO.FR> > Subject: Re: Van/camper rentals in Europe? > > I guess this is the standard price in France in > July. Renting a car is > expensive partly because the VAT is very high > (around 20%). It's about the > === message truncated ===

__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.