Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2005, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 24 May 2005 11:55:58 -0500
Reply-To:     wlail@OU.EDU
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Warren Lail <wlail@OU.EDU>
Subject:      Re: Pressure Bleeding the Clutch slave/master
Content-type: text/plain; charset=us-ascii

One of the most frustrating things about the clutch slave is trying to get it out! The nut and bolt nearest the engine is a project in and of itself. So, when I had my transmission out for the umpteenth time, I had a nut welded in place on the underside. When I went to reinstall the clutch slave, it took only a couple of minutes. If you have your transmission out for any reason, have someone tack-weld a nut under there for you. You will be glad you did.

Warren Lail 88 Westy "Billy Bones"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.