Would help to know your local. To get the old ones of you will need the right wrench/socket combination and possibly combinations. First clean with a tooth pick or similar all of the holes in the heads of the six bolts holding each of the joints (24 total). They are probably full of grime. Then determine if you need the hex or trisquare or both to remove the bolts. 6mm hex and/or the 12 point jimt
On 5/31/05 2:18 PM, "Jim Comer" <Shadesof2worlds@CS.COM> wrote: > I was wondering if anyone knows a good place to buy remaned drive shafts? > Also how long should it take to replace both sides? (ball park) Ibought the > van used with 144,000 on it and they dont appear to have been replaced and i,m > hearing some clunking taking out out of first in the rear so i'm assuming the > cv's are going...Any input would be appreciated.... > Thank You > Jim > > 84 GL > 70 Westy > 66 Westy > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.