Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2005, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 1 Jun 2005 10:10:50 -0400
Reply-To:     Robert Harris <rdh24@CORNELL.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Robert Harris <rdh24@CORNELL.EDU>
Subject:      Re: hard shifting - different problem
Comments: To: Damon Campbell <damoncampbellvw@YAHOO.COM>
In-Reply-To:  <20050601011038.56995.qmail@web53510.mail.yahoo.com>
Content-Type: text/plain; charset="us-ascii"; format=flowed

Damon, It sounds like your shifter may not be centered fore-aft in the shift gate? Would be a matter of loosening the band clamp in the center of the shift rod and pulling the two sections of the rod apart by a bit. Left-right problems are adjusted by rotating the two shift rod sections against each other just a hair and then retightening the same clamp. When you crawl under there and stare at the linkage you'll see how it all works. Getting it adjusted is such a trial-and-error thing it seems... helps to have a beer handy and be in a very patient state of mind best, Robert H Ithaca, NY 84 Westy <www.people.cornell.edu/pages/rdh24/vw/index_vw.html>

At 06:10 PM 5/31/2005 -0700, you wrote: >When my tranny went out about 20k miles ago in the >middle of Yukon, Canada, i didn't know about the 3-4 >slider hub breakage thing and tried to mess with the >linkage to "fix" things. Obviously, this was a >mistake. The shop who ended up replacing the >transmission could never get it to shift into first >gear correctly. There are a couple shifting problems: > >#1) I have to push the lever over to the left as far >as possible for it to kind of go in to 1st gear. It >isn't horrible, but it is reluctant at times. What is >the fix for this? >#2) Additionally, the gates between gears 2 and 4 >don't really prevent the shifter from moving side to >side unless i pull the shifter all the way back (and >correspondingly, 1 and 3 separate very readily). What >is the fix for this? > >I have already tried adjusting the shift lever mount >plate up front, but it is maxed out in the direction >it wants to go. > >Thanks for any input on this :-) > >-Damon > >'84 Westy "The Van" w/2.3L WBX >Vancouver, BC > >__________________________________________________ >Do You Yahoo!? >Tired of spam? Yahoo! Mail has the best spam protection around >http://mail.yahoo.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.