I am bringing my van in to a local VW shop to convert from R12, replace the compressor (there is one leak in the system at the compressor - but that is getting replaced anyway). The shop indicated that they'll have to have some AC lines fabricated as part of the install, which leaves me wondering... The existing AC system goes from compressor in the rear to condensor in the front then back to an evaporator in the rear. Since the BEHR unit has its own internal evaporator wouldn't the AC line just T off of the existing lines coming out of the evaporator? Is there any reason that new lines would need to be run back to the compressor? Thoughts? Chris |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.