Here are 2 possiable solutions for you:They are at www.grainger.com. part #3KU71 and #3T475. These are on page 3624 of their cataloge. They are quick release couplings. Just screw one part on the access port and then use the "bayonet" fitting to stick the hose into the fitting. Screwing on the gages will unnerve anyone at times. These will allow you to easily attach gages without loosing any r-12. They are 90 degrees offset. I think the 2 hoses that attach to the rear of your compressor can be adjusted so that htey can still give you good access.You will have to loosen them up though first. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.