Date:         Wed, 22 Jun 2005 13:44:39 -0400
Reply-To:     Roger Sisler <rogersisler2000@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Roger Sisler <rogersisler2000@YAHOO.COM>
Subject:      Re: AC issues

Here are 2 possiable solutions for you:They are at www.grainger.com. part
#3KU71  and #3T475. These are on page 3624 of their cataloge. They are
quick release couplings. Just screw one part on the access port and then
use the "bayonet" fitting to stick the hose into the fitting. Screwing on
the gages will unnerve anyone at times. These will allow you to easily
attach gages without loosing any r-12. They are 90 degrees offset. I think
the 2 hoses that attach to the rear of your compressor can be adjusted so
that htey can still give you good access.You will have to loosen them up
though first.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.