Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2005, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 29 Jun 2005 19:11:20 -0700
Reply-To:     Karl Wolz <wolzphoto@WORLDNET.ATT.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Wolz <wolzphoto@WORLDNET.ATT.NET>
Subject:      Re: R134 conversion
Comments: To: Roger Sisler <rogersisler2000@YAHOO.COM>
In-Reply-To:  <vanagon%2005062920373529@GERRY.VANAGON.COM>
Content-Type: text/plain; charset="us-ascii"

Alcohol is alcohol. When you buy rubbing alcohol at a drug store, it is usually a mixture, and is so stated on the label. Alcohol will mix with water, and stay in solution (won't separate like oil and water). Yes, there are different kinds of alcohol, like methanol, ethanol, and isopropyl alcohol, but they are all available straight or as a mixture with water.

Fuel dryer is alcohol. Water will condense in your fuel tank and a small amount will collect under the gasoline, where it cannot evaporate. If you dump a pint of alcohol in your gas tank every so often, it will absorb the water and allow it to be burned off.

Karl WOlz

> -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of > Roger Sisler > Sent: Wednesday, June 29, 2005 5:31 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: R134 conversion > > I once took apart a vanagon reciever- dryer,just to see what what was > inside. The reciever is seperated into an upper chamber, and a lower > chamber.They are the same size. These chambers are seperatecd with a wire > mesh about 8 gage in thickness. The upper chamber is empty. The lower > chamber contains the desicant. This desicant is in the form of little > balls ,about the size of buck shot. This lower chamber is packed full of > this stuff. All in all , it looks to be a very heavy duty unit. I think it > will survive a roasting. It has a bit of oil inside, so do be careful and > considerate of this when baking. There is no easy way to remove this oil. > When converting to a 134a system , this may be ok. 80 percent of the > systems oil must be removed for proper conversion. If the rest of the > system is cleaned well, the 1 or 2 ounces in the dryer will be > ok. As for mineral spirits, works well for me, and is > approved by several sources. I put a vacuum pump on the system for about 20 > hours to get all condensables out.I think any alcohol has water already in > it, except for grain alcohol.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.