Date:         Sun, 17 Jul 2005 18:30:10 -0500
Reply-To:     rrecardo@WEBTV.NET
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Robert Cardo <rrecardo@WEBTV.NET>
Subject:      Re: Input shaft question
Comments: To: Jonce Fancher <streetbugs@WHISPLLC.COM>
In-Reply-To:  Jonce Fancher <streetbugs@WHISPLLC.COM>'s message of Sun, 17 Jul
              2005 19:11:46 -0400
Content-Type: Text/Plain; Charset=US-ASCII

<<I've got to replace the seal for the stub axle to the trans.>>

Simple.
Remove the axle's.
Pop off the drive flanges ( after you remove the retaining nuts )
Remove the seals, replace the seals, put the flanges and the nuts back
on.
Put the axles back on the drive flanges.
The seals are external so they pop right out.
Your Done.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.