Hey guys.... Grrrrrrr... I need suggestions... i have a 84 here that i just resealed... (heads) it's been 8 hours that i am trying to start that van without success.. Every components where checked...(Fuel-air-fire), injection wiring and all FI components, AFM, that stupid 84 hall-sender and idle system control... EVERYTHING... mechanical timing and so on... am over my head with this van... of course, it came here ont's own so i created the problem... the only thing that was not change is the slow moving starter....??? still, it's turning enought... You should also know that the van started yesterday for about 15 sec. it died after and never started again.... i have fuel, air and fire (basic rule)... Every single wire to the ECU was checked, every possible FI components were checked per the book.... Any suggestions????????? maybe am not seing something obvious.... Remember, it's an Dijiget... Regards, Ben http://www.benplace.com/ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.