Date:         Fri, 22 Jul 2005 15:30:23 -0400
Reply-To:     Roger Sisler <rogersisler2000@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Roger Sisler <rogersisler2000@YAHOO.COM>
Subject:      Re: water pump replacement

Sorry about the link. It is www.vanagonauts.com. I checked it ,but no
advice about water pump replacement is there.Sorry. When I removed my old
pump, I had the same machineing you described. It allows leakage of cooled
water with a bit of warm water(I think).Less efficency,might be a problem
with a/c in the hottest weather.I repaired mine with , what else, but jb
weld. Ta Da!!!!I sanded the aluminum surface till rough, and then cleaned
it up with mineral spirits. I pressed a lump of the afore mentioned weld
into the crevace and allowed this oversized piece to set up. When set, I
used a full sized file to flatten the product to the correct size.I used
the surface of the engine case as the guide. When I began to cut metal with
the file, I was done.Perfect fit.No problems. This was last March, I think.