Ed wrote: > I received several general warnings about having the right tools, and what a pain it can be, but is there anyone out there who can answer my original question- What specific difficulties did you encounter if you replaced your header pipes? Any advice on overcoming these difficulties? > > Thanks > Ed > Rust and corrosion. Nuts and bolt heads which were 13 mm typically have eroded so that a 13 mm 6 pt socket slips. (Always use 6 pt sockets) If the nut is about the right shape You may be able to drive a 7/16" or 12 mm socket on and get enough grip. I believe that I once even went down to 11 mm. Of course these fasteners should be soaked with PB blaster or Rust Eater, etc. for as long as practical before even trying to turn them. It may help to apply your liquid of choice when the engine is warm. It may also help to tap the offending part 200 times. :-) When removing steel bolts or studs from an aluminum head, personally, I want the aluminum cold as when removing spark plugs. Maybe this is just a superstition; metallurgists on the list may correct me. Heating frozen nuts is of course a common strategy, but a flame has to be handled very carefully in such close quarters. An oxy-acetylene torch with a small tip is best, because it can heat the part quickly. Second best is probably a MAPP gas torch, but the flame is spread out more. Ordinary propane might do the trick if that's all you have. Other things to try when desperate: Cut most of a nut away with a Dremel, carefully so that you don't hurt the stud. Stretch a nut by squeezing it as hard as you can in three different directions with large ViseGrips. If you remove a bolt or stud from the aluminum head and the new bolt doesn't go in well because of dirt or corrosion and you don't have a metric tap to clean it out, you can make a crude thread chaser from an extra bolt. Cut a couple of longitudinal slots across the threads with a Dremel cutoff wheel. Then clean off the burrs with a small file.
Use stainless steel when reassembling. Anti-seize compound where steel meets aluminum is also a "good thing". Good luck, Larry A. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.