Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2005, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 12 Aug 2005 09:45:46 EDT
Reply-To:     THX0001@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         George Goff <THX0001@AOL.COM>
Subject:      Re: Zombie Thread - Broken Stebro Muffler Bracket / Malcolm's
              trip + FIBER EXHAUST
Comments: To: RAlanen@aol.com
Content-Type: text/plain; charset="US-ASCII"

In a message dated 8/12/05 6:54:59 AM, RAlanen@AOL.COM writes:

<< the doughnut gasket joint in an exhaust system is used to allow placement of the components so that there is no undue stress. A solid flat joint allows no repositioning of the components to the best position. That said there are two types of doughnut gaskets available on the market today. Asbestos fibre ones and solid steel ones. >>

. . . and there are two distinct types of joints in which these doughnuts are to be used. Just because both seals are rings does not mean that they can be interchanged, Frank, regardless of the bad advice you have given to your long suffering customers. Since you apparently do not recognize the difference, I'll explain.

The bevels of the steel doughnut are made to seal to like beveled surfaces formed by chamfers on the ID's of solid flanges or else by the flared ends of exhaust pipes with "spin" flanges. This joint has to be drawn together so tightly that the spring bolt remedy suggested by Dennis would not be effective because the springs would become bound long before bolt tension enough to seal the joint was generated.

The fiber seal is meant to be used in a type of slip joint along with the spring bolts. One side of this joint is a solid flange set back from the end of the pipe an amount equal to the depth of the ring. The other side is flared and has a loose flange. In such an assembly the fiber ring is installed over the protruding pipe end which protects the gasket from erosion ("burnout").

Shit, Frank, I only wish you had talked to me sooner . . . I could have saved you and Stebro all those "many years of testing" and your customers all the hardship they have endured.

George


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.