$100 plus $50 for engineering design time. When do I start? TEMiller ----- Original Message ----- From: "John Rodgers" <inua@CHARTER.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Tuesday, August 09, 2005 4:53 PM Subject: (NVC) Motors - DC Electric
> Everybody -- I'm at it again. > > I need to build a couple of turntables for product display and would > appreciate any suggestions for motor types to drive them. I'm not a > whiz-bang on electrical or scavenging so I am calling for...."HeeLLPPP!!" > > Variable speed from zero to 100 rpm is my goal for the turning table > it'self so I need something in a simple, small, DC motor with some sort > of rheostat speed control.. The load on the display disk will not exceed > 15-20 lbs. I have seen such built using parts from treadmills ( don't > know where to look on that one) and disk ot tape drive motors for older > computers, especially old IBM stuff. > > Don't have a clue where to look for that kind of stuff. > > Any input at all would help. > > Thanks, > > John Rodgers > 88 GL Driver > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.