Hello,
One of my first projects on my '90 Westy was installing the GoWesty shoulder belt for the rear passenger seat. I was very nervous about cutting up my very nice interior. Although there is a factory hole for the belt it is difficult to determine where it is through the somewhat thick interior panel. After calling GoWesty they told me you can see the mounting hole from the outside through the vent. So using my tape measure and translating the outside measurement to the inside using the window as a reference I was able to determine fairly accurately where the hole was located and then cut with a utility knife......missed the center by about ½". Fortunately the retractable seat belt housing covered up my slightly enlarged access hole. Eventually I will need to install the driver's side rear ( once my 3 year old gets a little older), which will be a bit more challenging with the need to cut through the cabinets.
Phil Trenholme '90 Westy Santa Cruz, CA |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.