Date: Tue, 13 Sep 2005 20:32:10 +1200
Reply-To: pronks <john.pronk@XTRA.CO.NZ>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: pronks <john.pronk@XTRA.CO.NZ>
Subject: Re: interesting lifter thinking?? 1.9L still a problem child
(update)
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
reply-type=original
Dennis is correct, adjust them as per the Bentley, 2 turns and let them
bleed down.
You guys who are adjusting for 0 or 6 thou lash are asking for trouble!
Have you seen the small wire clip holding the guts of the lifter in its
bore? You are going to pump that sucker out. I have seen this on a couple of
waterboxers now. Found the wire clips in the sump area, probably after they
had passed thru every lubricated internal surface of the engine!
If you want 6 thou clearance install solid lifters.
I have never had a problem adjusting lifters. If you are you are either not
starting from zero lash when you set the two turns, not waiting for them to
bleed down, you have stuffed lifters, you have no oil pressure or a
combination of all these.
Thanks for your time,
John.
----- Original Message -----
From: "Dennis Haynes" <dhaynes@OPTONLINE.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Tuesday, September 13, 2005 3:02 PM
Subject: Re: interesting lifter thinking?? 1.9L still a problem child
(update)
>2 turns is correct. After setting, you must walk away for a couple of
> hours to let them bleed down. Bentley doesn't make this clear, most
> likely due to the fact that the only time they should be adjusted is
> during assembly. If they are really gunked up, then so is the whole
> engine and an overhaul will be needed anyway. They are almost at the end
> of the oil train. The oil that goes through them, also goes through the
> push rods and lubricates the rocker arms. Imagine what went through the
> bearings if debris is in the lifters.
>
> Dennis
>
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf
> Of Roger Sisler
> Sent: Monday, September 12, 2005 10:50 AM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Re: interesting lifter thinking?? 1.9L still a problem child
> (update)
>
> This is an issue sure to cause debate. I must tell you that I once set
> my
> lifters per the Bentley(lash +2 turns)and got no compression. The valves
> remained open even when "closed" and this collapsed 2 of the lifters for
> good.The lifters were gunked up before hand, but I believe this wont be
> healthy for even new lifters.The best I can figure out is that Bentley
> ment
> the settings to be lash +.2 turns.However I am certin this will not be
> agreed with.What I settled on , and what works fine for me is lash + 1/4
> turn.I think this sets the lifters at the mid range of their travel.Good
> luck in this prosess, Roger
>
|