In a message dated 9/18/05 8:03:12 PM Eastern Daylight Time, rrecardo@WEBTV.NET writes:
> Using an Exacto razor saw, or anything else that is sharp, cut this > plastic strip outa there. > Doesn't have to be pretty right this second. > > Take the srcews out of the sides of the cover, and pull it straight up. > > Do whatever your gonna do, and clean up the cut with anything you want > to use , and fasten the cover back down to the floor under the seat. > > Your done with this crazy project. > > I know this is in the archives. > I did this 5 years ago and thought it was an insane project to yank the > seat to get to the heater then, as I do now. > the only reason VW put that strip under the vent hole on the rear heater cover housing is to add $$ to the R&R job at the service dept.. :<) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.