In a message dated 9/25/05 11:37:32 AM, inua@CHARTER.NET writes: << I cannot help but wonder why a full surface gasket properly cut, and greased with some silicone sealant or other like plumbers Goop, would not make a perfectly acceptable and very likely permanent fix for this thing. >> John, It's plastic so it will likely distort with the clamping pressure of the fasteners and although it might be clamped tight around the fasteners, the slight flex in the assembly will lessen the clamping force at its midpoint and possibly leak. The last time I replaced a rear heater valve, I am fairly certain that I used a standard round section O-ring which sealed perfectly. George |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.