Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2005, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 Sep 2005 11:17:51 -0400
Reply-To:     dhaynes@OPTONLINE.NET
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <dhaynes@OPTONLINE.NET>
Subject:      Re: Do the voltage regulater brushes "chrip"like a bird when they
              get short?
Comments: To: roger sisler <rogersisler2000@YAHOO.COM>
In-Reply-To:  <20050929150222.17562.qmail@web60220.mail.yahoo.com>
Content-type: text/plain; charset=us-ascii

Alternator chirping could either be the belt slipping, or if it is a metallic chirp, the rear bearing or bushing has failed and the rotor is hitting the stator. Usually, worn brushes also mean worn slip rings on the rotor and the bearings are almost gone also. Brushes may buy some time but a rebuild is in order. Some after market brushes or brush-regulator combos have very soft brushes that will wear quickly. Just had a set in FUN BUS that wore at in a little over a year. Amazing how the original alternator went over 130K and I've dealt with replacing or servicing the replacements 3 times since.

Dennis

----- Original Message ----- From: roger sisler <rogersisler2000@YAHOO.COM> Date: Thursday, September 29, 2005 11:02 am Subject: Do the voltage regulater brushes "chrip"like a bird when they get short?

> I am getting this intermittant chirping , ecpecially when cold. > At first I thought it was wheel bearings in the rear. Then I > figured it was my new (10 hours to replace) water pump about to > go south. Finally I snuck up on this noise this morning and > discovered not a nest of little birds, but a bird like sound > coming from the rear of the alt. There is this bird like > chirping coming from the rear of the altenator though. The voltage > at my new auxillery battery is 13.25 V. I think it is suposed ot > be about 13.5 , or 14 volts. Could this be the end for the > brushes? I see that the voltage regulater is ez to remove. Can > this be done with the altenator still installed?I see that vendors > sell new brushes forabout $3. the Bentley says that these can be > resoldered on. Is this a good way to go? > > > --------------------------------- > Yahoo! for Good > Click here to donate to the Hurricane Katrina relief effort. >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.